The LED tail lights on the 2015 Mustang are pretty sweet. When they're off they're visibly red and stand out a lot.
Since the trunk panel is black, it only makes sense to darken the tail lights a little bit. In addition to making them darker, the film protects the tail lamps against scratches.
These smoked black out overlays are available in two shades. Once dry, they will not fall off when washing your vehicle.
Please follow the instructions listed in the additional tab.
2015 Mustang V6 Tail Light Smoke Overlays (Black Out)
2015 Mustang Ecoboost Tail Light Smoke Overlays (Black Out)
2015 Mustang GT 5.0 Tail Light Smoke Overlays (Black Out)
This Part Fits
- 2015 V6 Mustang - Tail Light Smoke Overlays (Black Out)
- 2015 Ecoboost Mustang - Tail Light Smoke Overlays (Black Out)
- 2015 Mustang GT - Tail Light Smoke Overlays (Black Out)
3 out of 4
Installation of the black out kit is not difficult, but requires a little time. The black out kit has a strong adhesive material on the backside. This makes it nearly impossible to move if placed on a surface dry. Hence we must use a wet installation. Place a dab of dish soap on each overlay before you apply it. After placing the soap on the overlay mix it with water until the entire back side of the overlay feels slippery.
Clean the surface of the tail light. We do not want to trap any dirt, dust, etc between the tail light and the overlay. Use the straight edge of the tail light to help you align the overlay. The surface of the tail light is not flat. This is why we must use the hair dryer to stretch the material. Use your fingers to press the material down. Do not use a squeegee. Apply heat as needed. Until you get a feel for how the heat affects the material, use short bursts of low heat. Once you know how to apply the heat, you can use more. To prevent the material from crimping under the force of your fingers, you may need to apply more water. You will continue to massage the material until it lays flat on the surface of the tail light.
Repeat with the other segments of the tail light until installation is complete. If the ends do not want to stick, use more heat.
|Additional Warranty Information||No|
Be the first to review this product
Upload images for this product
Feel free to share pictures of your vehicle with this product!